How to Install

• Install filters downstream of aftercoolers and air receivers at the lowest installation temperature and as close to the point application as possible. This ensures in wet systems as much water and oil vapour has condensed out as possible which can be removed by the coalescing filters.
• Installing close to the application reduces the risk of pipe scale.
• Filters should not be installed downstream of quick opening valves and should be protected from possible reverse flow or other shock conditions.
• Install a combination of main line filtration near the compressor installation before entry to the ring main and install terminal filtration at the critical points. Remember especially in existing installations the contamination already in the pipe system downstream of the filters will take a long time to disappear and probably never will completely. E. Purge all lines leading to the filters before installation. F. Install filters in a vertical position keeping sufficient place below the filters for element change